MotiPix Vintage Kodak 5248 35 mm x 100 Ft. Motion Picture ECN-2 Process Film 100T
Description
KODAK VISION Color Film / 5248 Classic Vintage Cold stored
Please note that this is Motion Picture Film with Rem Jet backing and IS NOT meant for standard C-41 Processing. It is being offered as a fun, fantastic way to shoot Motion Picture film in your still camera (or Lomokino) and is being offered in the spirit of experimentation and creativity. Film is VINTAGE so make sure to allow a few stops or bracket your initial roll for creative results.
This film is rated at 100T terms of film speed and can be shot from 25 - 100 ISO or so, which can lead to lots of fun! This film is Tungsten balanced, and again, in the name of shooting fun, you need not bother with a filter, if you are looking for cool Lomo effects. Enjoy!
EASTMAN EXR 100T Film / 5248
KODAK VISION Color Intermediate Film 5248 is a medium-speed tungsten-balanced color negative camera film intended for general motion-picture production. It features microfine grain, very high sharpness, and high resolving power. The wide exposure latitude of this film makes it especially suitable for both indoor and outdoorphotography under a wide variety of conditions
This film is balanced for use with tungsten light, but you can expose it with daylight with filters. The emulsion contains a colored-coupler mask for good color reproduction in release prints.
Tungsten (3200K)—100 Daylight—64 Use these indexes with incident- or reflected-light exposure meters and cameras marked for ISO or ASA speeds or exposure indexes. These indexes apply for meter readings of average subjects made from the camera position or for readings made from a gray card of 18-percent reflectance held close to and in front of the subject. For unusually lightor dark-colored subjects, decrease or increase the exposure indicated by the meter accordingly.
Motion Picture Films with the Rem Jet backing in 35 mm Cassettes and Bulk Rolls. As this film requires special processing (ECN-2) and is absolutely not to be sent out to any regular labs, because the protective backing can "gum up the works" in any standard commercial C-41 processing environment, the majority of this stuff gets processed DIY with our C-41 Kits. You can take off the backing before or during your own processing regimen and it is not that difficult to remove (just an extra step really) and there are a few dedicated labs out there that will process for you but it is implicit that you only use a lab that is dedicated to ECN-2 process.